SKU: EN-1001setup-GAS
Enderle 1001 Bugcatcher Blown GAS-E-85 Complete Setup w Pump-Drive-Shut-Off- Filter

Enderle 1001  Blown GAS or E-85  Bugcatcher Injector - Smooth Top 28 SQUARE INCHES  

 - Up to 1300 HP with approx. 18 lbs boost - approx.*

Gas Not Recommended if idle is a consideration  

Fits all 6-71 8-71 10-71 14-71 with standard Blower Top Opening 

Supports about 1300  hp    

Fuel pump 7.00 gpm Waterman  700 Sprint *  

-8AN Shut off Valve w Cable and bracket

-12 AN 70  micron fuel Filter- Inlet Cone  

-8  60 Micron  Fuel Filter to the Barrel Valve  

Timing cover - SB Chev , BB Chev,     OR * Option for : LS-Early Hemi- SB Ford -BB Ford 

OR

Belt Drive that drives from the bottom blower pulley 6 bolt only   with a motor plate 

Instructions:

Butterfly colors-  Blue-Red-Black - Polished   ( Brass only with offshore  Bug catcher )  

All you should need is hoses to plumb it

Setup and flowed for your engine

Our Casting Disclaimer: 

 Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.

    In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  

It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out.

 We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.

Bugcatcher kit ,  Bug Catcher   1002