SKU: EN-BAU3-44-BG
Enderle Big and Ugly 3 - BAU3 Progressive Linkage 4-3/8" B Flys Blown Gas-E-85 Alkydigger

Blown Gas or E-85  model  - Progressive  linkage so can run on gas better  

Comes with stainless lines, nozzles,  jets, valves, Ready to sit on Blower and go.

Big and Ugly 3 Butterfly  Designed  Like a Top Fuel or funny car injection 
 4- 3/8"  Butterflys    45 sq inches of air surface-  good for most engines up to 550  cu in 

New  Enderle the Big and Ugly  BAU-3 with Progressive Linkage 

This has 4-3/8" butterflies which makes it great for  

smaller cubic inch engines to 425-550

 Is approximately 8.75" tall.

 Width Outside  of linkage = 18"

Width Outside of  housing  14"

 and is approximately 8.75" tall.

Comes setup with:

• barrel valve - K Valve or Black square valve - your choice
• SS fuel lines and 2 rubber hoses
• nozzles and bodies
• idle and check valves
• distribution block
• bypass jets
• Progressive Linkage

See our "Partial" version for EFI conversion.

Our Casting Disclaimer:

Hilborn and Enderle Scoops and Hat Injections are made from older casting molds that are original molds and are cast in very limited quantities.

There are casting flaws that have been there from the beginning and will always be there.   We cannot do anything about this and the manufacturers will not.   

 In addition, as time has gone on, many foundries have closed, leaving the castings to be done by very small Mom and Pop foundries.  It is most common to see pits and small imperfections which either will not buff out or would cause too much damage to the casting to try to buff it out. 

We do not give refunds, allowances, re-buffing jobs, or swap outs for other injectors.