Holley wiring harness to FAST remote IAC (307016)

The below schematic should be used to wire the FAST remote IAC to the Holley main harness. Removal of the flat Holley connector will be required to splice in the supplied square connector. Use the below schematic for proper installation.

Holley harness purple/yellow to connector terminal A

Holley harness purple/blue to connector terminal B

Holley harness purple/black to connector terminal C

Holley harness purple/white to connector terminal D

The pin layout is provided in case it is needed. The barrels of the supplied connector points towards you with the connector tab on top and the wires out the rear for correct terminal orientation.

**558-303 Harness - Mag Pick-up Ignition Harness** HLY-558-303
$81.95

558-443 Cable - CAN to USB Dongle Communication Cable — **558-443 USB/CAN Communication Cable - For Holley EFI - Sniper EFI - Terminator X** HLY-558-443
$73.85

558-307 Universal Coil On/Near Plug Harness — **558-431 Crank/Cam Ign. Harness. Fully terminated harness** HLY-558-307
$172.95

**558-431 Crank/Cam Ign. Harness. Fully terminated harness** HLY-558-431
$91.78

**558-438 15' long sealed USB data cable remote tuning** HLY-558-438
$121.95